1
T/TS Space Temperature Sensor Installation Instructions TG101133A Issue 2/B 20/02/07
Important: Retain these instructions
Installation Instructions
T/TS
Space Temperature Sensor
View of underside
No 6 (M3.5)
screw hole
cable to IQ
M20 cable gland
INSTALLATION
The sensor should be mounted on a wall, away from sources of heat and out of direct sunlight.
Thermistor
IQ Input Channel
Sensor
C
I/P
polarity
independent
(4) Wire as shown below and replace cover.
(5) Replace cover and tighten screws.
(6) Set IQ input channel link for thermistor input.
(1) Remove cover by unscrewing 4 retaining
screws.
(2) Fix to wall using 2 no.6 (M3.5) screws, through
holes on centres as shown.
(3) Route the cable through the cable entry.
Note: this sensor can be used to measure radiant heat. Ensure the sensor is mounted in a position where a good representation
of the radiant heat can be measured.
75 mm (2.95”)
63 mm (2.48”)
80 mm (3.15”)
52 mm (2.05”)
Comments to this Manuals